- Meter detects faulty wiring in need of repair without removing outlets cover plates, or panel covers: Faulty splices and connections, Incorrect wiring, Undersized wiring, Faulty GFCIs, Faulty or incorrectly wired AFCIs, Incorrect line voltage, Poor ground quality
- Testing efficiency relevant test data (voltage, voltage drop, hot and neutral voltage drop, voltage with load, ground impedance) is presented on a single large display to save operator time no scrolling or switching screens needed
- Verifies if wiring is tested for load carrying ability that it meets electrical code recommendations for voltage drop under load
- User selectable 0, 10,15 and 20 amps loads to verify performance of the electrical system
- Incorrect wiring or voltage drop test failure is clearly indicated by flashing screen
- Will not trip circuit breakers or blow fuses during the test
- Tests GFCI and AFCI operations
- Check ground quality for safety and ability to support sensitive electronic equipment
- Measure fault currents
- Save money and time by eliminating guess work
- NOTE: The Inspector™ III does not check the condition of wiring insulation
- Load: Constant 0, 10, 15 or 20 AMP simulation regardless of line voltage
- Operating Voltage: 95-140 VAC /-2%, /- 2 digits
- GFI Trip: 6.0 mA nominal to trip GFI, 30 mA to trip RCD
- AFCI Trip: Up to 8, 120 AMP pulses within 1/2 second period
>
Each Unit Includes
- Power Cord
- 9V Alkaline Battery (Installed)
- Users Manual
- Carrying Case
